Krone Big Pack 890 HS - Setting the Bale Length

KRONE ISOBUS-Terminal CCI 100
97
Pos: 24.30.17 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Grundbild Handbe trieb/Einstellen der Ballenlänge Handbetri eb Bild HS Baureihe @ 64\mod_ 1300182624651_78.doc @ 581664
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
1/2
Fig.57
Pos: 24.30.18 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Grundbild Handbe trieb/Einstellen der Ballenlänge Handbetri eb HS Baureihe @ 63\mod_1299 852886404_78.doc @ 576958
7.4.3 Setting the bale length
Note
(BP 890;1270;1290)
The bale length can be set in the range from 100 - 270 cm (39 - 106 inches).
(BP 1290 HDP; BP 12130)
The bale length can be set in the range from 100 - 320 cm (39 - 126 inch).
Note
Only adjust the bale length at the start of a bale, otherwise in-between lengths could arise.
Pos: 24.30.19 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Scroll-Rad an wählen,springen,erhöh en bzw. verringern, speichern @ 43\mod_1275295 180531_78.doc @ 390064
• You can use the scroll wheel to select the desired selection (A) (the selection box is
highlighted in color)
• Pressing the scroll wheel allows you to jump to the selection box (the selection box is
highlighted in color)
• Turning the scroll wheel increases or reduces the value
• Pressing the scroll wheel causes the setting to be applied and returns you from the
selection box
Pos: 24.30.20 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165