Krone Big Pack 890 HS - Activating the Cutting System; Blade Changing

Operation
159
Pos: 30.15.9 /BA/Ei nstellungen/Schnei dwerk/Schneidwerk ak tivieren BigPack @ 20\ mod_1238594744307_78. doc @ 223814
9.4.3 Activating the cutting system
Fig. 93
To activate the cutting system, the upper (1) and lower (2) blade control systems must at least
be switched on (position 1) and the cutting system is moved up hydraulically as far as it will go.
Pos: 30.15.10 /W HB/Überschriften 2/K-O/M esserwechsel @ 8\mod_12196 57285958_78.doc @ 119937
9.5 Blade Changing
Pos: 30.15.11 /BA/Si cherheit/Schnei dwerk/Warnhinweis Mess erwechsel Handschuhe tr agen @ 20\mod_12385953451 66_78.doc @ 223904
WARNING! - Blade changing
Effect: Severe injuries to fingers and hands
• Wear protective gloves to remove / install blades!
Pos: 30.15.12 /BA/Ei nstellungen/Schnei dwerk/Messerwec hsel allgemein Big Pack @ 20\mod _1238595529135_78.doc @ 223928
Blades are changed on the right and left side of the machine. Jobs on the right hand side of the
machine are described below. The same applies for the left hand side of the machine.
Pos: 30.15.13 /BA/Ei nstellungen/Schnei dwerk/Warnung Sc hneidwerk hochfahren @ 20\mod_1 238595825370_78.d oc @ 223952
Warning! – Raising the cutting system without retracted and locked cutting system
halves
Effect: Damage to the cutting system
• Make sure that both cutting system halves are orderly retracted and locked before raising
the cutting system
Pos: 30.15.14 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165