Placing in Storage
274
Pos: 36.9 /Überschri ften/Überschri ften 2/U-Z/Vor Beginn der neuen Sai son @ 0\mod_1197386024 448_78.doc @ 20081
14.3 Before the Start of the New Season
Pos: 36.10 /BA/Sic herheit/Gefahrenhin weise/Großpackenpre sse/Gefahr War tung allgemein @ 17\mod_12365809 40714_78.doc @ 205248
DANGER! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving.
Effect: Danger to life, injuries or damage to the machine.
• Switch off the tractor engine, remove the ignition key, and engage the flywheel brake
• Secure the machine and tractor against rolling
• Switch off the P.T.O. shaft and uncouple it
• After the repair, maintenance, cleaning work or technical modifications are completed,
install all protective covers and safety devices properly again
• Avoid skin contact with oils, greases, cleaning agents and solvents
• Hydraulic liquids escaping under high pressure can cause severe injuries. In the event of
injuries or burns due to oils, cleaning agents or solvents, contact a physician immediately
• All other safety instructions must also be followed to avoid injuries and accidents
Pos: 36.11 /BA/Einlager ung/Großpackenpres se/Vor der Saisaon @ 17\ mod_1236582596980_78. doc @ 205298
• Before placing the machine into service again, initiate the knotting process manually and
run through the baler manually. As you do so, check the functionality of the knotter and
the needles
• Clean the knotter of materials used to preserve it during storage (vegetable oils)
• Remove the grease from the twine retainer drive disc and clean
• Grease all lubrication points and oil the chains. Wipe away grease that has come out of
lubrication points
• Replace the oil in all gearboxes
• Check hydraulic hoses and lines for leaks and replace them if necessary
• Check the air pressure in the tyres and refill if necessary.
• Check all screws to make certain they are tight or retighten them if necessary
• Check all electrical connection cables and the lighting. Repair or replace if necessary
• Check the entire setting of the machine and correct if necessary
• Check the operating functions
• Check the functionality of the knotter shaft brake (to the right on the knotter shaft)
• Re-read the operating instructions thoroughly
Pos: 36.12 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
