Maintenance – lubrication
255
Pos: 34.51.18 /BA/W artung/Großpackenpre ssen/Schmierung / Sc hmierplan/Laufrol len der Messerhebel absc hmieren @ 24\mod_1241695 903648_78.doc @ 247898
13.5 Lubricating the rollers for the blade lever
Fig. 187
• Lower the cutting system with the tractor hydraulics (with the comfort electronics system:
Activate the tractor hydraulics and hold down “Lower blade bar” on the control unit display
or on the machine buttons until the cutting system is lowered all the way down)
• Remove the ignition key and turn off the electrical system on the control unit
• Apply the flywheel brake
• Secure the tractor and machine against rolling
• Unlock the cutting system half and remove it as far as the stop (right hand and left hand
machine side)
• Lubricate all grease nipples for the rollers of the blade levers
• Push in the half of the cutting system on the side (right hand and left hand side of the
machine) until the locking lever (3) snaps into place by itself
• Raise the cutting system hydraulically
Pos: 34.51.19 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
To Next Page
Loading...
