kruss DSA100 - Page 6

page 4 Contents
12.5.2 Power supply / Communication ................................................................................................ 85
12.6 Filling / Filling level ................................................................................................................................ 85
12.7 Fitting the temperature sensor ......................................................................................................... 86
12.8 Covering the needle inlet .................................................................................................................... 86
Appendix .......................................................................................................................................... 87
I Computer requirements ...................................................................................................... 87
II Exchanging cameras ............................................................................................................. 90
IIa) Assembly ................................................................................................................................................... 90
IIb) Horizontal alignment ............................................................................................................................ 92
III Assembling an interface board for software-controlled axes if ordered
afterwards .................................................................................................................................. 92
IIIa) Safety notes .............................................................................................................................................. 92
IIIb) Procedure .................................................................................................................................................. 93
IV Mounting steps for a multi-dosing unit if ordered afterwards .......................... 96
IVa) Assembling the syringe driver unit(s) ............................................................................................. 96
IVb) Assembling the syringe revolver .................................................................................................... 102
V Addresses and mounting of the electronic module EM3201............................ 105
Va) Overview .................................................................................................................................................. 105
Vb) Slots and addresses ............................................................................................................................. 106
Vc) Mounting ................................................................................................................................................ 107
VI Test liquids for multi-dosing unit DS3222-3228 .................................................... 111
VII For DSA1 with DS3222-3228: Copying the DCM.ini file ...................................... 112
VIII Warranty and caveat emptor ........................................................................................ 112
IX Copyright and right to make alterations .................................................................... 112