10-17
Troubleshooting > Troubleshooting
Printed images are fuzzy.
Printed images are cut
off.
Is the device used in an
environment with high humidity or
where the temperature or humidity
changes suddenly?
Use in an environment that has
suitable humidity.
―
― Select the [System Menu/Counter]
key > [Adjust/Maint.] > [Service
Setting] > [Drum Refresh], and
then select [Yes].
―
Printed images are
skewed.
Are the originals placed correctly?
When placing originals on the platen,
align them with the original size
indicator plates.
page 5-2
When placing originals in the
document processor, align the
original width guides securely before
placing the originals.
page 5-3
Is the paper loaded correctly? Check the position of the paper
width guides.
page 3-4
page 3-8
― Perform center line adjustment. For
more information about how to do
so, contact your service
representative.
―
Irregular horizontal lines
appear in the image.
― Contact your service representative. ―
Printed images have
vertical lines.
Is the slit glass dirty? Clean the slit glass. page 10-2
Dirt on the top edge or
back of the paper.
Is the interior of the machine dirty? Open the right cover. If the machine
interior is dirty with toner, clean it
using soft, dry, lint-free cloth.
page 10-2
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
