8-DW GPU Model cable routing
Follow the instructions in this section to learn how to do cable routing for8-DW GPU Model.
Identifying connectors
Go through the following sections to acquire necessary information before starting cable routing.
• For the connectors on system board, see “System-board connectors” on page 34.
• For the connectors on the drive backplane, GPU distribution board, rear riser, and front I/O expansion
board, see “Identifying connectors” on page 58.
8-DW GPU Model configurations
Cable routing is different by configuration. See the table below for the configuration that matches your
server, and refer to the corresponding cable routing guide.
Rear riser 1
Front I/O expansion board Configurations
V
Configuration D
V
Configuration E
Refer to the corresponding cable routing guide:
• For Configuration D, see “Configuration D cable routing” on page 95
• For Configuration E, see “Configuration E cable routing” on page 101
Chapter 3. Internal cable routing 93
To Next Page
Loading...
