Figure 208. Installing the 2.5-inch drive backplane to the module
After you finish
1. Reinstall the 2.5-inch drive backplane module. See “Install the 2.5-inch drive backplane module” on
page 271.
2. Reconnect the power and signal cables to the 2.5-inch drive backplane.
3. Reinstall the 2.5-inch hot-swap drive or drive bay filler (if any). See “Install a 2.5-inch hot-swap drive” on
page 265.
4. Complete the parts replacement. See “Complete the parts replacement” on page 328.
Front I/O expansion board module replacement
Follow instructions in this section to remove and install the front I/O expansion board module.
Remove the front I/O expansion board module
Follow instructions in this section to remove the front I/O expansion board module.
About this task
Attention:
• Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to ensure that
you work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 14.
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See “Remove the server from rack” on page 124.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See “Remove the top cover” on page 225.
Chapter 4. Hardware replacement procedures 275
To Next Page
Loading...
