• YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Make sure the fan cage is installed in the chassis. See “Install the fan cage” on page 144.
Step 2. Align the fan to the fan slot in the fan cage; then, insert the fan into the fan cage and press it until it
clicks into place.
Note: Press the fan to make sure they are seated correctly on the system board.
Figure 90. Installing a fan
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 328.
Flash power module replacement
Follow instructions in this section to remove or install the flash power module.
Remove the flash power module
Follow instructions in this section to remove the flash power module.
About this task
Attention:
• Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to ensure that
you work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 14.
Chapter 4. Hardware replacement procedures 147
To Next Page
Loading...
