1. Reinstall the 2.5-inch drive cage assembly. See “Install the 2.5-inch drive cage assembly” on page 269.
2. Complete the parts replacement. See “Complete the parts replacement” on page 328.
Retimer assembly replacement
Follow instructions in this section to remove and install the retimer assembly.
Remove the retimer assembly
Follow instructions in this section to remove the retimer assembly.
About this task
Attention:
• Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to ensure that
you work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 14.
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See “Remove the server from rack” on page 124.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See “Remove the top cover” on page 225.
b. Remove the 2.5-inch drive cage assembly. See “Remove the 2.5-inch drive cage assembly” on
page 267.
c. Remove the network adapters. See “Remove a network adapter” on page 179.
d. Remove the front I/O expansion board module. See “Remove the front I/O expansion board
module” on page 275.
Step 2. Remove the fan cage. See “Remove the fan cage” on page 143.
Step 3. Remove the cross bar.
a.
Unfasten the four screws that secures the cross bar to the chassis.
b.
Lift the cross bar out of the chassis.
318
ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
