• Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to ensure that
you work safely.
• Touch the static-protective package that contains the drive to any unpainted metal surface on the server;
then, remove the drive from the package and place it on a static-protective surface.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Align the front I/O expansion board with the five screw holes on the rear of the system-board; then,
lower the front I/O expansion board into the chassis.
Step 2. Fasten the five screws to secure it to the chassis.
Figure 185. Installing the front I/O expansion board
After you finish
1. Reconnect the required cables.
2. Reinstall the network adapter to the front I/O expansion board. See “Install a network adapter” on page
180.
3. Complete the parts replacement. See “Complete the parts replacement” on page 328.
GPU adapter replacement
Follow instructions in this section to remove and install a GPU adapter.
Note: For a list of the supported GPU adapters, see:
https://static.lenovo.com/us/en/serverproven/index.shtml
Remove a GPU adapter
Follow instructions in this section to remove a GPU adapter.
250
ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
