SXM GPU Model cable routing
Follow the instructions in this section to learn how to do cable routing forSXM GPU Model.
Identifying connectors
Go through the following sections to acquire necessary information before starting cable routing.
• For the connectors on system board, see “System-board connectors” on page 34.
• For the connectors on the drive backplane, front I/O expansion board, and retimer assembly, see
“Identifying connectors” on page 58.
SXM GPU Model configurations
Cable routing is different by configuration. See the table below for the configuration that matches your
server, and refer to the corresponding cable routing guide.
Drive quantity OCP Ethernet adapter Configurations
Eight drives Configuration F
Four drives V
Configuration G
Refer to the corresponding cable routing guide:
• For Configuration F, see “Configuration F cable routing” on page 108
• For Configuration G, see “Configuration G cable routing” on page 114
106
ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
Need help?
General