SW10 switch block
The following table describes the functions of the SW10 switch block on the system board.
Table 17. System board SW10 switch block description
Switch number
Default position Description
1
Off
Changing this switch to the On position to resets the RTC. A
momentary toggle is all that is required. To avoid excessive CMOS
battery drain, do not leave this switch in the On position.
3
Off
Reserved
Parts list
Use the parts list to identify each of the components that are available for your server.
The ThinkSystem SR670 V2 parts list varies by model. Refer to the parts list specific to each model to identify
the components.
• “The 4-DW GPU Model (2.5-inch drive configuration) parts list” on page 39
• “The 4-DW GPU Model (3.5-inch drive configuration) parts list” on page 43
• “The 8-DW GPU Model parts list” on page 47
• “The SXM GPU Model parts list” on page 51
38
ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
