From To
Front panel
1 Front panel cable
System board
1 Front panel connector
Figure 102. Connecting the front panel cable
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 328.
Heat sink Torx T30 nut replacement
Use this information to remove and install a heat sink Torx T30 nut.
Remove a heat sink Torx T30 nut
This task has instructions for removing a PEEK (Polyether ether ketone) Torx T30 nut on the heat sink.
About this task
Attention:
• Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to ensure that
you work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 14.
Chapter 4. Hardware replacement procedures 159
To Next Page
Loading...
