Step 3. From the front of the rack, install server into the rails.
a.
Tilt the server and slowly lower the its rear end; then, push the rails toward the server and
make sure the farthest nailheads on server’s left and right side go into the slots on the rail.
b.
Slowly lower the server down and make sure the other 3 nailheads on server’s left and right
side slip into corresponding slots.
Note: Inspect the sides of the rails to make sure the nailheads are placed in the slots.
Attention: You can only install the server successfully when the rails are fully extended.
Rack front
Figure 75. Installing the server into the rails
Step 4. Slide the server into rack.
a.
Push up the latches on the rails.
b.
Push the server all the way into the rack.
130
ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
