Figure 144. Separating a processor from the heat sink and carrier
Step 3. Separate the processor carrier from the heat sink.
a.
Release the retaining clips from the heat sink.
b.
Lift the carrier from the heat sink.
c.
Wipe the thermal grease from the bottom of the heat sink with an alcohol cleaning pad.
Note: The processor carrier will be discarded and replaced with a new one. Make note of the color
of the discarded carrier since replacement carrier needs to be of the same color.
Figure 145. Separating a processor carrier from the heat sink
After you finish
• Install a replacement processor or heat sink. See “Install a processor and heat sink” on page 206.
Chapter 4. Hardware replacement procedures 205
To Next Page
Loading...
