Lenovo ThinkSystem SR670 V2 - Page 216

Figure 147. PHM components
1 Heat sink
9 Clips to secure processor in carrier
2 Processor identification label
10 Carrier triangular mark
3 Heat sink triangular mark 11 Processor ejector handle
4 Nut and wire bail retainer 12 Processor heat spreader
5 Torx T30 nut 13 Thermal grease
6 Anti-tilt wire bail 14 Processor contacts
7 Processor carrier 15 Processor triangular mark
8 Clips to secure carrier to heat sink
Notes:
• The heat sink, processor, and processor carrier for your system might be different from those shown in the
illustrations.
• PHMs are keyed for the socket where they can be installed and for their orientation in the socket.
• See
https://static.lenovo.com/us/en/serverproven/index.shtml for a list of processors supported for your
server. All processors on the system board must have the same speed, number of cores, and frequency.
• Before you install a new PHM or replacement processor, update your system firmware to the latest level.
See “Update the firmware” in the ThinkSystem SR670 V2 Setup Guide.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
208 ThinkSystem SR670 V2 Maintenance Manual