• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See “Remove the server from rack” on page 124.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Remove the top cover.
a.
Press the release button on the top cover latch.
b.
Rotate the latch until the latch is fully open and the top cover is disengaged from the
chassis.
c.
Lift up the top cover from the chassis, and place it on a flat clean surface.
Attention:
• Service label is located on the inside of the top cover.
• For proper cooling and air flow, install the top cover before you power on the server.
Operating the server with the top cover removed might damage server components.
Figure 157. Removing top cover
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the top cover
Follow instructions in this section to install the top cover.
About this task
226 ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
