Figure 178. Installing an EDSFF hot-swap drive
Step 4. If you have additional drives to install, do so now; if any of the drive bays is left empty, fill it with a
drive bay filler.
Step 5. Check the drive status LED to verify that the drive is operating correctly.
• If the yellow drive status LED is lit continuously, the drive is malfunctioning and must be
replaced.
• If the green drive activity LED is flashing, the drive is functioning.
Step 6. Reinstall the EDSFF drive cage cover back to the server.
Figure 179. Reinstalling the EDSFF drive cage cover
After you finish
If the server is configured for RAID operation through a ThinkSystem RAID adapter, you might have to
reconfigure your disk arrays after you install drives. See the ThinkSystem RAID adapter documentation for
additional information about RAID operation and complete instructions for using ThinkSystem RAID adapter.
Chapter 4. Hardware replacement procedures 243
To Next Page
Loading...
