Lenovo ThinkSystem SR670 V2 - Page 290

• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See “Remove the server from rack” on page 124.
Prepare the following screwdrivers to ensure you can install and remove the corresponding screws properly.
Torque screwdriver type list
Screw Type
Phillips #1 head screwdriver Phillips #1
Torx T10 head screwdriver Torx T10 screw
Note: Make sure you have an alcohol cleaning pad available.
CAUTION:
Do not touch the radiator fins. Touching the radiator fins might damage the L2A.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See “Remove the top cover” on page 225.
b. Remove the 2.5-inch drive assembly. See “Remove the 2.5-inch drive cage assembly” on page
267.
c. Remove the network adapters. See “Remove a network adapter” on page 179.
d. Remove the front I/O expansion board module. See “Remove the front I/O expansion board
module” on page 275.
Step 2. Remove the retimer assembly. See “Remove the retimer assembly” on page 318.
282
ThinkSystem SR670 V2 Maintenance Manual