Step 6. With a PH 1 head screwdriver, fasten the seven Philip #1 screws that secure the radiator to the
GPU tray. Install the screws with a torque screwdriver set to the proper torque. For reference, the
torque required for the screws to fully tighten is 0.3±0.03 newton-meter, 2.7±0.27 pound-inch.
Figure 225. Fastening screws to the radiator
1 Radiator
2 Cold plate assembly
292 ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
