2-6 Service Manual
4036-307, -308
User attendance messages
Additional messages may appear, and most are documented in the Menus and Messages Guide for this option
and the Service Manual for the base printer. The messages listed below pertain to the scanner portion rather
than the base printer.
User attendance messages
Error
code
Sub
codes
Display text Description Action
Clean scanner
glass
During a scanner calibration,
the firmware detects that a
scanner ADF or the flatbed
(scanner) glass may be dirty.
Touch Cancel Job if a scan job is
processing when the attendance message
appears. This cancels the job and clears
the message.
Touch Scan from Automatic Document
Feeder if the page jam recovery is active.
Scanning resumes from the ADF
immediately after the last successfully
scanned page.
Touch Scan from flatbed if page jam
recovery is active. Scanning resumes from
the flatbed immediately after the last
successfully scanned page.
Touch Finish job without further
scanning if page jam recovery is active.
The job ends at the last successfully
scanned page, but the job is not canceled.
Successfully scanned pages go to their
destination: copy, fax, e-mail, or FTP.
Touch Restart job if job recovery is active
and the job is restartable. The message
clears. A new scan job containing the
same parameters as the previous job
starts.
Disk Full – Scan
Job Canceled
The scan job cancels or stops
due to insufficient hard disk
space.
Note: The scanner finishes scanning
currently committed pages in the ADF, but
data is lost when the job cancels itself.
Touch Continue to clear the message.
Fax Memory Full There is no memory to
complete a fax job. Any
attempted fax jobs are
canceled.
Touch Continue to clear the message.
To Next Page
Loading...
