Liebert Hipulse E - 9.9 Procedure to completely switch ON\OFF the UPS at the ups display control panel.

User Manual Liebert Hipulse E Chapter 9 - Operating Instructions
Single or '1+N' UPS System Procedure
(07/04) Page 9-11
MODEM CONNECTION
> ON/OFF UPS CONTROL<
RELOAD UPS DATA
RESET BUFFERS
9.8 Adding a single Module to an existing system
This procedure should be carried out only by trained service personal.
9.9 Procedure to completely switch ON\OFF the UPS at the ups display control panel.
1. From the Default window press the ENTER key: the Main Menu Window will display:
2. Select FUNCTION and press ENTER key:
Before being allowed into the FUNCTION windows you are requested to
enter a password. This is achieved by pressing the UP arrow key repeatedly
until the first digit displays the character required, you then press the
DOWN arrow key once to move on to the second digit. This action is
repeated for all eight digits. When the PASSWORD has been completed
press the ENTER key.
Caution
This operation gives the operator access to modify UPS’s operating mode, it is advised that only trained qualified
personnel should attempt to do that.
3. You now have access to all function windows.
Press the DOWN arrow key until the cursors have selected NEXT PAGE -
press the ENTER key.
4. Press the DOWN arrow key until the cursors have selected ON/OFF UPS CONTROL.
Press the ENTER key.
Caution
The following window allows the operator to select the UPS inverter ON or OFF, select the rectifier ON or OFF,
select the rectifier to manual or float voltage and to switch OFF the Line (bypass) voltage to the load
IF YOU ARE NOT SURE OF WHAT YOU ARE DOING - THEN DO NOT DO IT.
WRITE SAVE
MOVE EXIT ESC
ENTER PASSWORD
00000000
MEASUR./ALARM HIST.
> FUNCTION <
MAINTENANCE
SETUP
BATTERY TEST
GENERATOR
PANEL SETUP
> NEXT PAGE <