Lightware VINX-120-HDMI-ENC - Page 75

6. Programmer's Reference  

Serial Port Settings
Setting the Port Availability
ç <port>
Setting the Baud Rate of the Port
ç <port>
Setting the RS-232 Port Mode
ç <port>
Setting the Data Bits
ç <port>
Setting the Stop Bits
ç <port>
Setting the Parity
ç <port>
Arranging the Extenders to Groups

ç 

ç 

ç 

ç 

ç 
DIP Switch Enable
ç 
Setting the Video Stream ID
ç 
Setting the No-signal-screen
ç 
Setting the Signal Type of the Output Video Signal
ç <out>

ç 
Establishing the USB Connection
ç 
Audio-related Commands

ç 
Setting the Audio Input Selection Mode
ç 

ç <in>.SignalPresent


ç <port>.AnalogVolumedB
Setting the Volume (Exact Value)
ç <port><value>
Setting the Volume (by a Step Value)
ç <port>:stepVolumeDb(<value>)

ç <port>.AnalogVolume
Setting the Volume (in Percentage)
ç <port><value>
Setting the Volume (by a Step Value in Percantage)
ç <port>:stepVolumePercent(<value>)

ç <port>.AnalogMute
Setting the Mute State
ç <port>.AnalogMute



