Lightware VINX-120-HDMI-ENC - LW3 Decoder-Related Commands; Output Video Signal Resolution and Scaling; Output Signal Type and USB Connection State

6. Programmer's Reference VINX-1x0-HDMI Extenders – User's Manual 62

6.6.9. Setting the HDCP State

be seen on a non-HDCP compliant display if the content allows it; see the HDCP Management section.
Command and Response
ç <in>
æ <in>
ATTENTION!  applySettings method must be called always to store the
new setting. If the HDCP State is changed the device is restarted automatically.
Parameters
See the previous section.
Example
ç 
æ 
ç 
æ 
ATTENTION!  The EDID information cannot be read by the source attached to the HDMI input of an Encoder
if HDCP is disabled on the input. That may stop the video transmission in the case of certain source devices.
6.7. Decoder-related Commands
6.7.1. 
The resolution and the refresh rate of the outgoing video signal can be queried.
Command and Response #resolution
ç <out>.Resolution
æ <out>
Example
ç 
æ 
6.7.2. 
Command and Response #scaler
ç <out>
æ <out>
Parameters
 Parameter description Parameter values
 Scaling mode OFF: Scaling is disabled, the resolution is not changed.
EDID: the resolution is set to meet with the preferred timing of
the sink device.
MANUAL: Scaling is set manually.
Example
ç 
æ 
See more information about the scaling modes in the Main Settings (Decoder) section.
6.7.3. Setting the Scaling Mode of the Output Video Signal
Command and Response
ç <out>
æ <out>
Parameters
See the previous section.
Example
ç 
æ 
See more information about the scaling modes in the Main Settings (Decoder) section.
6.7.4. 
Command and Response #signaltype
ç <out>
æ <out>
Parameters
The  can be DVI or HDMI.
Example
ç 
æ 



