6. Programmer's Reference
6.11. Video Wall Settings
Basic Rules #videowall
▪ One Decoder can be a part of only one video wall.
▪
characters.
▪
▪ All the Decoders and the Encoder must be set one-by-one. The set parameters are applied only in the
given device.
Short Instructions
Step 1. All the affected VINX devices must be in Multicast mode. See the
Multicast) section to set the mode if necessary.
Step 2. Set the same Video Stream ID in the Encoder and in all desired Decoders. Use the front panel DIP
Setting the Video Stream ID section.
Step 3. Assigning a
section.
6.11.1. Setting the Name of the Video Wall
Set the name of the video wall in the Decoder devices as follows:
Command and Response
ç
æ
Parameters
The video wall must have a unique name () within a system ; the length of the name shall not
Example
ç
æ
6.11.2. Assigning a Decoder to a Video Wall
ATTENTION! Setting the name of the video wall is highly recommended (see the previous section).
Command and Response
ç
æ
Parameters
The include the following order of settings:
Parameter description
Total number of columns
Total number of rows
Column position of the Decoder
Row position of the Decoder
<wid> The width of the screen (display area) (mm)
<hei> The height of the screen (display area) (mm)
<Hgap>
<Vgap> Vertical gap between the sinks (mm)
<Btop>
<Bbot>
<Blef>
<Brig>
Example
ç
æ
Explanation
INFO:
To Next Page
Loading...
