7. Firmware Upgrade VINX-1x0-HDMI Extenders – User's Manual 78
7.1. Built-in Web or LDU2
the methods:
Function Built-in Web LDU2
Platform
Google Chrome
mac OS
Installation
needed only
Required
-
-
7.2.
▪ Upgrade all VINX devices
▪ signal processing is not performed. The normal operation mode is
suspended as the device is switched to bootload mode.
▪ Do not interrupt
▪ The settings and parameters (e.g. User EDID memory, video wall settings) will not be lost by upgrading
7.3.
device.
▪
▪
loading.
7.4.
WARNING! Never disconnect the power source from the VINX devices during the upgrade! Interrupting
you do not have the chance to install a software or you have just a few devices.
7.4.1. Firmware Upgrading Steps
Step 1. Get the necessary rmware pack (*.lfp or *.lfp2 le
device).
Step 2. Establish the connection
in the .
Step 3. Navigate to the Advanced Settings tab.
Step 4. Upgrade Firmware section and press the Choose le
OK.
Firmware Upgrade via the Built-in Web Page
Step 5. Press the Upgrade Firmware
process is started automatically.
Step 6. The progress bar and a short label will show the current state of the process.
Step 7.
off and on again the device is recommended.
INFO:
To Next Page
Loading...
