10. Appendix
Microphone Input (VINX-110AP-HDMI-DEC only)
Gain in the signal path * ...............................................................+20dB
Peak level without distortion ...................................
Total Harmonic Distortion (THD) ..............
THD+Noise ........................................................0.3% (approx. -60dBFS)
Signal to Noise ratio (SNR) .........................................................62dBFS
Dynamic Range (DR) ...................................................................72dBFS
Crosstalk ............................................................. 100% (mono channel)
......................................... above -3dB
* compared to the forward audio signal level. If this input is connected to
a powered equipment hum noise issue may occur. This case an isolation
transformer (a passive DI box) can help.
ATTENTION!
feed the connected electret (condenser) microphone. Thus it is not
suitable for dynamic microphones which do not contain isolation
or an impedance matching transformer. (Danger of damage of the
microphone.)
Analog Audio Output
Connector type .....................................
Audio formats ..........................................................................2-ch PCM
Signal transmission .................................................. unbalanced signal
Sampling frequency ................................................
Volume adjustment ................................................................
Connector type ..................................................
Signal transmission ....................................................Dante® or AES67
Supported channels .....................................................2-channel stereo
Sampling rates ..............................................................
INFO:
10.2. Delay in the Video Transmission
Due to the design of the devices frame delay is in the signal
transmission from the Encoder towards the Decoder. Below tables
show the cases and the measurable delay.
No Scaling, No Frame Rate Conversion
(approx. 30 sec), then the frame delay stays constant as written above.
Active Scaling, No Frame Rate Conversion
30 sec), then the frame delay stays constant as written above.
Active Frame Rate Conversion (Scaling Does Not Matter)
Input resolution Output resolution Delay Frame delay
1080p60 1080p60 1.1
22ms 1.1
1.1
720p60 720p60 1.1
Input resolution Output resolution Delay Frame delay
720p60 1080p60 1.1
1080p60 1.1
1080p60 720p60 1.1
1080p30 2160p30 38ms 1.1
Input resolution Output resolution Delay (min) Delay (max)
1080p60 18ms
80ms
80ms
110ms
70ms 110ms
720p60
10.3. Factory Default Settings
10.4. DIP Switch States
Parameter
IP address
Dynamic (AutoIP with DHCP fallback)
RS-232 port setting
DIP switch state 0000
Video stream ID 1
Connecting method Multicast mode
Selected video input
(VINX-210AP-HDMI-ENC)
Auto
Selected audio input Auto#1
Emulated EDID (HDMI input)
Emulated EDID (VGA input)
User EDID memory Empty (cleared)
Output video mode (Encoder) Movie mode
Output scaling (Decoder) Pass-through, no rotation
Available video walls Empty (cleared)
DIP switch state Video Stream ID
0000 0x0
0001 1 0x1
0010 2 0x2
0011 3 0x3
0100
0101
0110 6 0x6
0111 7 0x7
1000 8 0x8
1001
1010 10 0xa
1011 11 0xb
1100 12 0xc
1101 13 0xd
1110 0xe
1111 0xf
To Next Page
Loading...
