6. Programmer's Reference VINX-1x0-HDMI Extenders – User's Manual 66
6.9. Serial Port Settings
ATTENTION! The new port settings are stored but applied only if the applySettings method is called which
applySettings method is
INFO: Below listed commands can be used to set the RS-232 port parameters. To query the current value
of a parameter use the GET command, e.g.: GET /MEDIA/UART/P1.BaudRate.
6.9.1. Setting the Port Availability
ATTENTION! The port must be enabled for the RS-232 data transmission; use this command.
Command and Response #rs232 #rs-232 #serial
ç <port>
æ <port>
Parameters
If the parameter is 0 (or false
the value is 1 (or true) the RS-232 data transmission is enabled.
Example
ç
æ
ç
æ
INFO: The applySettings method will save and apply the new value and makes the extender reboot.
6.9.2. Setting the Baud Rate of the Port
Command and Response
ç <port>
æ <port>
Parameters
The
Example
ç
æ
ç
æ
INFO: The applySettings method will save and apply the new value and makes the extender reboot.
6.9.3. Setting the RS-232 Port Mode
The RS-232 port can be set to Pass-through or Command Injection mode. The introduction of these modes can
be found in the RS-232 Interface section.
Command and Response
ç <port>
æ <port>
Parameters
If the parameter is 0 (or false) the mode is Pass-through. If the value is 1 (or true) the port is in
Command injection mode; in that case, use the 6752
Example
ç
æ
ç
æ
INFO: The applySettings method will save and apply the new value and makes the extender reboot.
6.9.4. Setting the Data Bits
Command and Response
ç <port>
æ <port>
Parameters
The parameter can be set to the following values: 6, 7, 8
Example
ç
æ
ç
æ
INFO: The applySettings method will save and apply the new value and makes the extender reboot.
To Next Page
Loading...
