Lightware VINX-120-HDMI-ENC - Static IP Address and Subnet Mask Settings; Static IP Address and Subnet Mask Configuration; Gateway Address Configuration; Gateway Address Query and Setting

6. Programmer's Reference  

6.5.5. Setting the DHCP State (FW 1.x.x)
DIFFERENCE:  
Command and Response
ç 
æ 
Parameters
See the previous section.
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value and results the extender to reboot.
Explanation
The IP address assignment is set to static, thus, you have to set it manually.
6.5.6. Setting a Static IP Address
DIFFERENCE:  Make sure the IP address setting is static:
In case of FW 1.x.x: when the DhcpEnabled property is false you can set a static IP address.
In case of FW 2.x.x: when the IpSetupMode property is static you can set a static IP address.
Command and Response
ç 
æ 
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value and results the extender to reboot.
6.5.7. 
Command and Response
ç 
æ 
Example
ç 
æ 
6.5.8. Setting a Static Subnet Mask
DIFFERENCE:  Make sure the IP address setting is static:
In case of FW 1.x.x: when the DhcpEnabled property is false you can set a static IP address.
In case of FW 2.x.x: when the IpSetupMode property is static you can set a static IP address.
Command and Response
ç 
æ 
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value and results the extender to reboot.
6.5.9. 
Command and Response
ç 
æ 
Example
ç 
æ 



