Lightware VINX-120-HDMI-ENC - Troubleshooting Firmware Upgrades; Handling Failed Firmware Upgrades

7. Firmware Upgrade VINX-1x0-HDMI Extenders – User's Manual 83


Click on the Start Update button to start the procedure. The status is shown in
percent in the right side of the device line and the overall process in the bottom
progress bar.
INFO:  
Done
successfully and a message appears; you can close the software.


down and restarting the device is recommended.
START UPDATE
7.8. If the Upgrade is not succesful
▪ Restart the process and try the upgrade again.
▪ 
written in the User's manual of the device. Please note that backup and restore cannot be performed
in this case.
▪ If the backup cannot be created for some reason, you will get a message to continue the process
without backup or stop the upgrade. A root cause can be that the desired device is already in bootload

▪ If an upgrade is not succesful, the Export log button becomes red. If you press the button, you can

 #bootload



