5.10. Video Wall Setup
ATTENTION! This tab is displayed only when the device is in Multicast mode. Although changing
parameters usually takes effect within an acceptable period of time, it might happen that feedback is not
received and not visible on the web page for several seconds.
Basic Rules #videowall
▪ One Decoder can be a part of only one video wall.
▪
characters.
▪
The Video Wall Setup Page
5.10.1. Creating a Video Wall
Step 1. Navigate to the Video Wall Setup page.
Step 2. Press the New video wall button. Enter
the desired name of the wall (press
the pencil icon to change) and
press the Enter or click on the pencil
icon.
Step 3. Press the Change Video Wall Size button
new window will pop up, click on the
Step 4. Drag and drop the Decoders to the
desired place in the wall.
Step 5. Press the Apply changes button to
save the settings.
ATTENTION! A New video wall is stored
only when at least one Decoder is linked
to the wall.
5.10.2. Identify the Decoders
Identify Receivers button.
In this case, the IP address and the position in the Video wall are displayed on the
connected screens.
Identify Receivers
To Next Page
Loading...
