6. Programmer's Reference VINX-1x0-HDMI Extenders – User's Manual 61
6.6.5. Setting the Video Input Selection Mode
DIFFERENCE: Below command is valid for VINX-210AP-HDMI-ENC device only.
Command and Response
ç
æ
Parameters
Parameter description Parameter values
The currently applied input
selection method.
0: Auto (see the details in previous section)
1: HDMI
2: VGA
Example
ç
æ
6.6.6.
in the Encoder:
▪ Movie mode
bandwidth. If the bandwidth is decreased the image quality will be lower, but the video streaming is
continuous.
▪ Graphics mode
bandwidth is decreased the image quality does not change, but frame drop may appear.
Command and Response #qualitymode #videoquality
ç
æ
Parameters
The value of the parameter shows the current mode setting: movie or graphic.
Example
ç
æ
6.6.7.
The video quality mode can be set in the Encoder (see the previous section for details about the modes):
Command and Response
ç
æ
Parameters
See the previous section.
Example
ç
æ
6.6.8.
The current state of the HDCP encryption can be queried at the input port; see the HDCP Management section.
Command and Response #hdcp
ç <in>.HdcpState
æ <in>
Parameters
If the parameter is 0, then the HDCP encryption is disabled at the port. If the value is 1, then
HDCP encryption is enabled.
Example
ç
æ
To Next Page
Loading...
