LM Trac 287 - Screen

LM 287 User Manual – 30.10.2023
26
4.4 Screen
NOTE
Due to variation of different functions between machines, your screen may
look partly different.
Figure 28 – main view
1. Fuel gauge and warning light
2. Tachometer
3. Speedometer (optional
accessory)
4. Fuel consumption
5. Engine temperature and warning
light
6. Water in fuel indicator
7. Oil pressure warning light
8. Engine fault indicator
9. Warning light
10. Rear view camera (optional
accessory) indicator
11. Speed range indicator
12. 4WD (optional accessory)
indicator
13. Differential lock indicator
14. Operating time counter
15. Engine overheat indicator
16. Driving lights indicator
17. Parking brake indicator
18. Hazard indicator
19. Turn signal indicators
20. Time & date
21. Flashing beacon indicator
22. Rear works lights indicator
23. Charge indicator
24. Front work lights indicator
25. Preheating indicator
26. Mirror heater (optional accessory)
indicator
27. Front cylinder hydraulics 1
/ bonnet tilting (optional
accessory) indicator
28. Indicator for activated socket
(optional accessory) for rear
tools
29. Front tool floating position
indicator
30. Front tool power supply
indicator
31. Regeneration indicator
32. Auto shutdown indicator
33. Warning information
1. The fuel gauge indicates the amount of fuel remaining in the tank.
2. The tachometer indicates the engine revolutions as 100 revs/min. The reading is multiplied by 100 (for example, 20 =
2,000 rev/min.)
5. The engine temperature gauge indicates the temperature of the engine coolant. The normal running temperature is
between 60…90°C. If the engine is overheating and warning light (15) illuminates, immediately adjust the engine
revolutions to idle and let the engine cool down for a moment. Turn off the engine and determine the cause of
overheating and correct it before continuing work. If the running temperature is too low, let the engine warm up to the