LM Trac 287 - Connecting Tools; Connecting Tools at the Rear of the Machine (Optional Accessory)

LM 287 User Manual – 30.10.2023
47
5.7.4 Connecting tools
► Connect a tool to the A frame (A or B, depending on your selection) or the three‐point device (C).
Figure 59
► Connect the hydraulic hoses.
WARNING
Ensure that the tool is securely locked to the A frame or the 3‐point
attachment before starting work with the machine.
Remove a connected tool as follows:
A. Lower the tool onto level ground.
B. Disconnect the hydraulic hoses. See 5.7.6 on page 48.
C. Disconnect the locking on the A frame or the 3‐point attachment.
D. Reverse the machine away from the tool.
5.7.5 Connecting tools at the rear of the machine (optional accessory)
Rear motor hydraulics is available as an optional accessory.
For more info about connecting / disconnecting hydraulic hoses see 5.7.6 on page 48.