LM 287 User Manual – 30.10.2023
83
► Install the filter (605129035920). Tighten the oil filter by hand. Do not overtighten the oil filter.
► When the oil stops draining, clean the drain plug, replace the gasket and retighten it in position in the oil sump.
Oil filling:
► Remove the oil filler cap (4) and add the correct volume of the correct oil.
► Start the engine and check that the oil pressure indicator turns off. Run the engine at low idle for two minutes. Perform
this procedure to ensure that the lubrication system has oil and that the oil filters are filled. Inspect the oil filter for oil
leaks.
► Stop the engine and allow the oil to drain back to the sump for a minimum of ten minutes.
► Check the oil level by using the dipstick (5). Add oil if necessary.
For the recommended oil, see 7.12 on page 100.
6.13.2 Primary fuel filter element replacement (26)
Fuel leaked or spilled onto hot surfaces or electrical components can
cause a fire. To help prevent possible injury, turn the main power switch
OFF when changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Figure 102
Primary fuel filter element (LMPE130306360) replacement:
► Place a suitable container under the water separator in order to catch any fuel that might spill. Clean up any spilled
fuel. Clean the outside body of the filter assembly.
► Open the drain valve (6) and open vent screw (1) and drain the filter. Close drain valve (6) and vent screw (1) hand
tight.
To Next Page
Loading...