LM 287 User Manual – 30.10.2023
50
6 MAINTENANCE
6.1 General
Correct, timely maintenance is one of the key requirements for the machine's operational reliability. The operator is
responsible for carrying out all periodic maintenance work according to the maintenance program as scheduled in the
maintenance table.
The intervals for periodic maintenance listed in the table apply to machines operating under normal conditions. Machines
under heavy load must be serviced more frequently.
► In this manual, this paragraph symbol indicates a requested work performance.
The work stages have been registered in their completion sequence.
To avoid personnel injury, carry out the following procedures before
starting maintenance:
► Drive the machine onto durable, level terrain or on a maintenance ramp/hoist.
► Apply the parking brake.
► Lower all tools onto the ground and stop the engine.
► Disconnect the main breaker and remove the key from the ignition.
► Attach a tag to the steering wheel that forbids starting the machine.
► If you lift up the bonnet/platform body, support it mechanically.
If the maintenance work requires lifting the machine, proceed as follows:
► Only use suitable lifting tools with sufficient strength.
► Support the raised machine with approved and sufficiently strong stands that prevent unintended movement of the
machine.
Never go under the machine before it has been secured in place in a safe
manner that meets all applicable regulations. Never go underneath a
raised bonnet / platform body unless it is tipped to its extreme position!
To Next Page
Loading...