LM 287 User Manual – 30.10.2023
34
Preheating indicator
This indicator is lit when the automatic preheating is operational.
Engine oil pressure indicator
This indicator illuminates when the engine oil pressure falls too low. The light is lit when power is switched on, and turns
off once the engine has started. If the indicator illuminates while driving, check the engine oil level.
High beam indicator
The blue indicator illuminates when the high beam headlights are switched on. You can switch between low beam and
high beam using the multi‐purpose switch on the steering column.
Turn signal indicator
This indicator flashes when the left or right turn signal is switched on. The turn signal can be switched on by using the
multi‐purpose switch on the steering column.
Parking brake switch
The parking brake is a disk brake switched on by spring force, and released by hydraulic pressure. Parking brake is
controlled electrically. The brake is always on when the engine is stopped. The indicator on the switch illuminates when
the parking brake is on. Always apply the parking brake before turning off the engine.
Motor hydraulics switch
3‐position switch, ON/OFF/ON. The motor hydraulics use can be run in two directions depending on the switch position.
In the middle position, the use of engine hydraulics is switched OFF.
Ignition switch
A more detailed explanation of ignition switch operation can be found under “Engine operation”.
Cabin fan switch
The fan switch has 4 positions:
0) OFF
1) Speed I
2) Speed II
3) Speed III
The highest speed is intended for quick cabin heating and windscreen defrosting. The lowest speed is usually used
together with air conditioning to create the weakest possible draught.
Heater control
This control is used to regulate the amount of water entering the heater core.
Air conditioning switch
To Next Page
Loading...