LPKF ProtoMat S64 - Page 127

ProtoMat S64/S104
Maintenance
V. 1.0 | LPKF Laser & Electronics AG
127/160
3. You can clean the interior with a vacuum cleaner if heavily soiled.
The tool adjustment station must not be cleaned with a vacuum cleaner because
the probe pin could be sucked in! Clean the tool adjustment station only with a slightly
damp cloth.
Fig. 126: Cleaning the interior with a vacuum
cleaner
4. Wipe the cover with a slightly damp cloth:
Fig. 127: Cleaning the cover
5. Connect the mains plug to the wall socket.

The system has been cleaned.