LPKF ProtoMat S64 - Page 130

Maintenance
ProtoMat S64/S104
130/160
LPKF Laser & Electronics AG | V. 1.0
Fig. 131: Cleaning the collet with a cylindrical
brush
10. Put on the latex lab gloves.
11. Use a small amount of grease when lubricating the tool collet shank:
Fig. 132: Lubricating the collet
Avoid overdosage of the collet grease!
12. Reinsert the collet wrench with the collet into the collet opening.
13. Turn the collet wrench clockwise until the collet sits hand-tight in the collet fixture.
14. Remove the maintenance materials from the system and close the cover.

The collet has been cleaned and lubricated.