LPKF ProtoMat S64 - Page 139

ProtoMat S64/S104
Maintenance
V. 1.0 | LPKF Laser & Electronics AG
139/160
 Replacing the fuse
Ensure that the following prerequisites are fulfilled before performing the described
tasks:
Prerequisites
Spare parts and auxiliaries
 The system is switched off.
 Flat-bladed screwdriver
 Fuse (250 VAC; T6.3 A; 20 x 5 mm;
according to EN 60127-2-3)
Fig. 151: Fuse holder
1. Disconnect the mains cable from the power supply.
2. Use a flat-bladed screwdriver to pull out the fuse holder.