LUMENIS smart532 - 2.13. EMC Guidance and Manufacturers Declaration; 2.13.1 Electromagnetic Emissions

UM-1151140EN, Rev. C, May 2016
2-19
Smart532
™
Laser Safety and Regulatory
2.13 EMC Guidance and Manufacturer's Declaration
2.13.1 Electromagnetic Emissions
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
The Smart532 is intended for use in the electromagnetic environment specified below.
The customer or the user of the Smart532 should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic Environment – Guidance
RF emissions CISPR 11 Group 1
The Smart532 uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
RF emissions
CISPR 11 Class [A or B] Class A
Harmonic emissions IEC
61000-3-2
[Class A, B, C, D, or
Not applicable]
Class A
Voltage fluctuations/ flicker
emissions IEC 61000-3-3
[Complies or Not
applicable]
Complies
[See 5.2.2.1 c) and
Figure 1]
The Smart532 is suitable for use in all
establishments other than domestic and those
directly connected to the public low-voltage power
supply network that supplies buildings used for
domestic purposes.