MacDon FlexDraper FD130 - Page 182

214683 158 Revision A
1003939
Figure 3.227: Case IH Combine Display
8. Install REEL FORE-BACK (if applicable).
1025380
A
B
Figure 3.228: Case IH Combine Display
9. Locate the HHC HEIGHT SENSITIVITY field (A), and
set as follows:
• If using a two-sensor system: Set HHC HEIGHT
SENSITIVITY to 250.
• If using a single-sensor system: Set HHC
HEIGHT SENSITIVITY to 180.
NOTE:
If hunting occurs during operation, decrease this setting
by 20 points at a time until hunting no longer occurs.
10. Set the HHC TILT SENSITIVITY (B) to 150. Increase or
decrease as desired.
1003940
Figure 3.229: Case IH Combine Display
11. Install FORE/AFT CONTROL and HDR FORE/AFT
TILT (if applicable).
OPERATION