Maxcess D-MAXE - Page 61

CONTROLLER MENUS: 1Y.3 JOB SETTINGS 7 - 5
D-MAXE with OI-B/OI-Nwww.maxcessintl.com MI 2-296 1 D
Prozessor bedienung.fm
Menu 1y.3.y1
Guidepoint Offset
Description The guidepoint of the selected job (F4 key) can be adjusted for
the corresponding drive with the
Guidepoint Offset .
Note:
The
Guidepoint Offset can also be set in menu 3y.3.y1 or
directly on the user level of "Automatic" mode (see
Shift
guidepoint, page 5-19
).
Menu
 Key sequence for menu 1y.3.y1:
The current setting of the
Guidepoint Offset parameter is shown
here.
 Enable the parameter for input
Input
Menu
1y.3.y1.1: Guidepoint Offset
 Position the cursor under the digit whose value you want to
change
 Change the value of the selected digit
 Save the entry or cancel
1y.3
→ Job Settings
or
1y.3.y1
→ Guidepoint Offset
or
...
... ...
1y
or
or
or