Maytag MDE17CS - Installation Information and Requirements; Tools and Parts Required for Installation

2-1
INSTALLATION INFORMATION
TOOLS AND PARTS
Parts supplied:
Remove parts bag from dryer drum. Check
that all parts were included.
Foot boot (4)
Dryer foot (4)
CS Dryer Models include:
Coin slide extension
Two screws.
Service door lock cam
Stack Dryer Models include:
High security coin box mounting plate kit
NOTE: The circuit diagram for this dryer is
located inside the lower panel.
Technical Specications:
220 – 240 V, 50 Hz, 1 ph, 3A max, AC
Clothes Capacity:
9 Kg max.
•
•
•
1.
2.
3.
•
1.
Gather the required tools and parts before
starting installation. Read and follow the
instructions provided with any tools listed
here.
Tools needed:
200 mm (8”) or 250 mm (10”) Pipe wrench
200 mm (8”) or 250 mm
(10”) Adjustable wrench
Flat-blade screwdriver
Star screwdriver
Adjustable wrench that opens to 25 mm (1”)
or hex-head socket wrench
Level
8 mm (5⁄16”) socket wrench
Utility knife
Vent clamps
Caulk gun and caulk (for installing new
exhaust vent)
Pliers
Stiff-bladed putty knife
Pipe-joint compound resistant to LP gas
(for gas dryer installation)
•
•
•
•
•
•
•
•
•
•
•
•
•
For complete installation instructions go to the Document Links Page