4-47
COMPONENT ACCESS - STACK DRYER
UNBOX STACK DRYER
To unbox a stack dryer, first make sure
there is enough clearance above the stack
dryer to allow the full height of the carton
to be removed above the stack dryer, or
remove the carton outside before moving
the stack dryer into the location.
Cut along the dotted line around the entire
base of the carton.
NOTE: Do not cut down the corners of the
carton.
Lift the carton up off the top of the stack
dryer. Remove the corner posts on all four
corners as the carton is lifted.
Remove the tape that holds the doors
closed during shipping.
NOTE: If the stack dryer will be moved
again, retape the doors before moving the
dryer
1.
2.
3.
4.
Check both doors for proper alignment
when closed.
If the top and bottom corners of the door do
not close evenly, open the door and make
sure the hinge screws are tight.
If the door requires slight adjustment, grasp
the door at the top and bottom corners
and apply a slight pressure in the direction
necessary to straighten the door.
Close the door and reinspect. Readjust as
necessary to align the door properly.
1.
2.
3.
4.
DOOR ALIGNMENT
To Next Page
Loading...
