4-6
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Remove the service access door on top of
the metercase (See page 4-3).
Remove the long 5/16” hexagonal coin slide
mounting bolt from inside the metercase.
Lift the coin slide up and pull it out of the
metercase.
1.
2.
3.
REMOVE COIN SLIDE - CS
The coin slide assembly may be installed
very tight and can require some coaxing
to get it to move upwards for removal. To
loosen this fit there are 4 adjustment screws
at the 4 corners behind the slide mounting
plate. They can be accessed easily after the
coin slide is removed.
4.
Long 5/16”
Hex Bolt
4 Adjustment
Screws
To Next Page
Loading...
