Maytag MDE17CS - Remove Broken Belt Switch; Remove Idler Pulley Wheel

4-35
Remove the dryer drum (See page 4-26).
Remove two star head screws from the
back of the motor bracket.
Remove the two wire connectors and
remove the switch.
1.
2.
3.
REMOVE BROKEN
BELT SWITCH
Remove the dryer drum (See page 4-26).
Gently pry the tri-clip off the idler pulley
shaft
Slide the wheel off of the shaft.
NOTE: There is another tri-clip behind the
wheel for proper spacing. Replace both tri-
clips when replacing the idler pulley.
NOTE: Do not lubricate this wheel or shaft.
Clean the shaft with ne steel wool to
eliminate squeaks.
1.
2.
3.
REMOVE IDLER
PULLEY WHEEL
Two Wire
Connectors
Two Star Head
Screws
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Idler Pulley
Tri-clip