mensor CPC6050 - Page 86

86 Operating Instructions - CPC6050
Modular Pressure Controller
CPC6050
Units Units code or text in table below Sets the instrument engineering units
Units? <sp>CCCC<cr><lf> Returns the instrument units in a text
string
Unitbase1 Units code or text in table below Sets the user 1 base engineering
units
Unitbase1? <sp>CCCC<cr><lf> Returns the user 1 base units in a text
string
Unitbase2 Units code or text in table below Sets the user 2 base engineering
units
Unitbase2? <sp>CCCC<cr><lf> Returns the user 2 base units in a text
string
Unitfact1 Multiplier factor Sets the user 1 unit mulitplier
Unitfact1? <sp>n.nnnnnE+nn<cr><lf> Returns the user 1 unit multiplier
Unitfact2 Multiplier factor Sets the user 2 unit mulitplier
Unitfact2? <sp>n.nnnnnE+nn<cr><lf> Returns the user 2 unit multiplier
Unlock None Releases Acquire locks
(see Acquire? and Release?)
UpperLimit Value inside primary transducer range
in current units.
Sets the Upper control limit for the ac-
tive transducer.
UpperLimit? <sp>xxxxxxx<cr><lf> Returns the upper control limit for the
active transducer.
Vent None Instrument placed in Vent Mode
Vent? <sp>(YES or NO)<cr><lf> Returns yes if instrument is in Vent, no
if otherwise
Volume AUTO or value in cc Sets the regulator volume in cc’s, or
Auto for automatic volume correction.
Applies to both SVR and Pump
Volume? <sp>AUTO or xxxx<cr><lf> Returns the system volume in cc's
Window Value in current units Sets the exponential lter window for
the active transducer
Window? <sp>n.nnnnnE+nn<cr><lf> Returns the exponential lter window
for the active transducer
Zero Desired pressure or ? Sets zero to set pressure or for ?,
clears previous value. CALDISABLE
must be OFF/NO.
Zero? <sp>n.nnnnnE+nn<cr><lf> Returns zero oset for active trans-
ducer