Enter the target program number and copy it using the "Save"
button.
If you wish to copy to a target program place that is already occupied
by another program, the security question will appear.
If the storage space available is insufficient to accept the selected
program, the following message will appear in the display:
"Insufficient storage space" will flash in the display.
Press the "Save" button to overwrite.
The overwriting process is carried out and the screen returns to the
"Copying" sub-menu.
Tip: When is pressed, or if after 30seconds no button has been
pressed, copying is not carried out and the display reverts to the
main menu.
Copy area
With this option you can copy an area from one existing program into
another program. This can add an area to the target program that it
did not previously have, or overwrite the existing area.
Select the area to be copied.
When this is selected, the display will show the following:
Press the multifunction selector, select the source program number
and confirm your selection.
Go to Source area and confirm.
Select the source are Pre-wash, Main wash or Rinse and confirm.
To Next Page
Loading...
Need help?
General
